High Efficiency Bulk Solid Pneumatic Conveying Transfer System
Product Description
This kind of conveying system works by pushing the material along
the pipe in a plug form, with the help of compressed air blown into
the pipeline by a pressure vessel.
Dense phase pneumatic conveying systems can be used to transport a
large range of bulk materials, both in the form of powders or
granules. They can reach distances longer than 500 metres and
capacities over 100 t/h.
The low conveying speed used in dense phase pneumatic systems helps
preventing the material degradation and preserves the product
quality and integrity. It is suitable to handle any kind of
product, including fragile, abrasive and lumpy materials and
blends.
Dense phase transport has a high product/air efficiency ratio. The
indicative ratio of air or gaseous fluid to the product is about
30L of gas per 1Kg of product. Thanks to the reduced amount of air
needed, this system allows reduced energy consumption.
Pneumatic conveying systems offer the benefit of low maintenance
costs: the number of spare parts and maintenance services needed to
maintain the system running is limited.
| Name | Pneumatic comveying system |
| Used for | PVC,food,Chemical,rubber |
| Material | Powder,Pellet |
| Capacity | 800-5000Kg/h |
| Powder,Pellet | Siemens 1200+HMI |
| Inverter | ABB |
| Capacity | 10kg-30t/h |
| Capacity | Conveying system |
Dense phase pneumatic transport sizing
The design phase of a pneumatic transport requires an analysis of
the material and the transport requirements (such as flow rate and
distance). Then, you need to work out the amount of air needed.
Air-Tec can engineer pneumatic conveying systems customised on the
initial analysis results.
Dense phase pneumatic systems are an efficient and cost-effective
solution for conveying abrasive and friable material. Slow convey
speed and low amount of air/gas used, means less wear and tear on
the pipeline, product integrity and reduced maintenance costs.
Dense phase pneumatic conveying systems can be used together with
any equipment, for example:
extractors
silos
screw conveyors
hoppers
big bag emptying stations
bag splitters and filters
Furthermore, they can be also used in ATEX settings thanks to the
possibility to use nitrogen for the transport.
Features
1.Minimal material degradation as the material is transported at
low velocity.
2.Handles wide variety of material such as fragile, abrasive and
friable as well as materials with high bulk densities.
3.Minimum wear and tear of the system.
4.Minimum Maintenance.
5.No material spillage, no dust emission, clean environment.
6.Low Noise operation.
7.Low air flow rate.
